TURBO
REMFLEX®
Turbo - Garrett, Greddy T25
Turbo Inlet Mounting Flange Gasket
2-1/16" x 1-5/8" Square Port
4 Bolt Holes with Bolt Spacing: (A) 1.562" x (B) 3.875"
1(ea)
Bolt Hole Spacing is measured from the center of one bolt hole to the center of the other bolt hole.
INSTALLATION TIPS: We want you to get the most from your new Remflex exhaust gaskets. To assure your complete satisfaction, please follow these basic installation guidelines:
1.) DO NOT BEND! Remflex gaskets are designed to withstand clamping force and incredible heat, but not bending.
If you bend them, they will break!
2.) Do not over tighten. When properly installed the flange should be tightened evenly - See the suggested torque range.
3.) Longer bolts aren't necessary. Though Remflex are thicker than other gaskets, standard length bolts will work fine.
4.) Do not use sealers. Silicone and other sealers cannot withstand the same temperature as Remflex gaskets, and can actually cause leaks.
Questions? 1-866-641-SEAL (7325)
[email protected] 
