1-3/8"w x 2-1/32"h Square Port

16-Bolt Pattern

332 thru 428 ('58-'76)

Header Applications

2/Set

(See RF3050 for "Weld Bead" Header Applications)

Most FE gaskets have “16 Bolt Hole Pattern”. Use the 8 bolt holes needed - the other 8 bolt holes do not impact the performance of the gaskets in any way.

1.)  DO NOT BEND!  Remflex gaskets are designed to withstand clamping force and incredible heat, but not bending.
            If you bend them, they will break!

2.)  Do not over tighten.  When properly installed the flange should be tightened evenly - See the suggested torque range.

3.)  Longer bolts aren't necessary.  Though Remflex are thicker than other gaskets, standard length bolts will work fine.

4.)  Do not use sealers.  Silicone and other sealers cannot withstand the same temperature as Remflex gaskets, and can actually cause leaks.

Questions?  1-866-641-SEAL (7325) [email protected]