FORD

V8

REMFLEX®

1-1/4"w x 1-5/8"h Square Port

2" Bolt Hole Spacings on each port

289, 302, 351 Windsor

For use with aftermarket Cylinder Heads - Fits GT40

For AFR Heads use PN 3083

Cross Reference: Fel-Pro 1415

Cross Reference: Edelbrock 7227

Header Applications

• 1.) DO NOT BEND! Remflex gaskets are designed to withstand clamping force and incredible heat, but not bending.
• If you bend them, they will break!
• 2.) Do not over tighten. When properly installed the flange should be tightened evenly - See the suggested torque range.
• 3.) Longer bolts aren't necessary. Though Remflex are thicker than other gaskets, standard length bolts will work fine.
• 4.) Do not use sealers. Silicone and other sealers cannot withstand the same temperature as Remflex gaskets, and can actually cause leaks.
• Questions? 1-866-641-SEAL (7325) [email protected]

INSTALLATION TIPS:  We want you to get the most from your new Remflex exhaust gaskets.  To assure your complete satisfaction, please follow these basic installation guidelines:

1.)  DO NOT BEND!  Remflex gaskets are designed to withstand clamping force and incredible heat, but not bending.
            If you bend them, they will break!

2.)  Do not over tighten.  When properly installed the flange should be tightened evenly - See the suggested torque range.

3.)  Longer bolts aren't necessary.  Though Remflex are thicker than other gaskets, standard length bolts will work fine.

4.)  Do not use sealers.  Silicone and other sealers cannot withstand the same temperature as Remflex gaskets, and can actually cause leaks.

5.)  Trim to fit.  Excess material around the flange and/or port mouth can be trimmed with a sharp utility knife or razor blade.

Questions?  1-866-641-SEAL (7325) [email protected]