2-Bolt Connector Gasket

2" Hole Size

2 (15/16") Elongated Bolt Holes (Can be slotted) with 3" to 4" Bolt Spacing

(Overall 4-7/8" Long x 2-15/16" Wide)

1 (ea)

Bolt Hole Spacing is measured from the center of one bolt hole to the center of the other bolt hole.

Slotted or Elongated Bolt Holes provide a range of Bolt Center-to-Bolt Center measurements to fit your particular application.

• Bolt Hole Spacing is measured from the center of one bolt hole to the center of the other bolt hole.
  
  
  Slotted or Elongated Bolt Holes provide a range of Bolt Center-to-Bolt Center measurements to fit your particular application.

INSTALLATION TIPS:  We want you to get the most from your new Remflex exhaust gaskets.  To assure your complete satisfaction, please follow these basic installation guidelines:

1.)  DO NOT BEND!  Remflex gaskets are designed to withstand clamping force and incredible heat, but not bending.
            If you bend them, they will break!

2.)  Do not over tighten.  When properly installed the flange should be tightened evenly - See the suggested torque range.

3.)  Longer bolts aren't necessary.  Though Remflex are thicker than other gaskets, standard length bolts will work fine.

4.)  Do not use sealers.  Silicone and other sealers cannot withstand the same temperature as Remflex gaskets, and can actually cause leaks.

5.)  Trim to fit.  Excess material around the flange and/or port mouth can be trimmed with a sharp utility knife or razor blade.

Questions?  1-866-641-SEAL (7325) info@remflex.com